Important Instructions - S&P TL-21 Instrucciones De Uso

GB
User instructions
Read these instructions carefully
before using the appliance.
The fan heater TL-21 is manufactured
in accordance with European Standard
EN-60335-2-30.
We recommend that you check the unit
immediately on un-packing to ensure
that it is in good condition and that it
works properly as any defect duc to
faulty workmanship or materials is
covered by the S&P guarantee.

IMPORTANT INSTRUCTIONS

– The heater should not be situated
under a current trap.
– Do not use this heater near a bath,
shower or a swimming pool.
– Do not handle the heater with your
hands wet.
– This symbol means "Do not
cover" the heater with objects that
prevent the air circulating freely.
Obstructing the airflow increases
the risk of overheating.
– If the cable is damaged, it must
be replaced in one of our Oficial
Services.
– Should flammable objets (curtains,
etc.) not be placed at less than 50
cm. from the heat circuit.
– While the heater is in use, the
cable must not be placed in front
of the air outlet.
– Keep the air inlet and outlet grilles
always clean. The device must
be unplegged before starting the
maintenance works.
– This appliance is not intended
for use by persons, including
children, with reduced physical,
sensory or mental capabilities, or
lack of experience and knowled-
ge, unless they have been given
supervision or instruction con-
cerning use of the appliance by
a person responsible for their
safety.
– Children must be under watch to
avoid that they could play with the
product.
– This appliance must not be used
connected to a programmer, timer
or another device that controls
heater connection automatically.
Power selection knob
Stop
Low Power Heating, quiet mode- 1.000 W
Low Power Heating- 1.000 W
High Power Heating - 2.000 W
Thermostat knob (B, fig. 1)
Maximum position of the thermostat
Minimum position of the thermostat
The thermostat controls the heater to
maintain the temperature selected bet-
ween minimum and maximum . When
selected room temperature is obtained
the thermostat will switch heater off,
and on, to maintain this setting.
Operation
1. Please ensure that the supply vol-
tage is in accordance with the product
rating plate (230 V 50 Hz).
6
(A, Fig. 1)