6. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed
50 °C (122 °F).
7. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The
battery cartridge can explode in a fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject to the Dangerous Goods Legislation requirements.
For commercial transports e.g. by third parties, forwarding agents, special requirement on packaging and
labeling must be observed.
For preparation of the item being shipped, consulting an expert for hazardous material is required. Please
also observe possibly more detailed national regulations.
Tape or mask off open contacts and pack up the battery in such a manner that it cannot move around in
the packaging.
11. Follow your local regulations relating to disposal of battery.
12. Use the batteries only with the products specified by Elite . Installing the batteries to non-compliant
products may result in a fire, excessive heat, explosion, or leak of electrolyte.
13. If the tool is not used for a long period of time, the battery must be removed from the tool.
14. During and after use, the battery cartridge may take on heat which can cause burns or low temperature
burns. Pay attention to the handling of hot battery cartridges.
15. Do not touch the terminal of the tool immediately after use as it may get hot enough to cause burns.
16. Do not allow chips, dust, or soil stuck into the terminals, holes, and grooves of the battery cartridge. It may
result in poor performance or breakdown of the tool or battery cartridge.
17. Unless the tool supports the use near high-voltage electrical power lines, do not use the battery
cartridge near high-voltage electrical power lines. It may result in a malfunction or breakdown of the
tool or battery cartridge.
18. Keep the battery away from children.
Save these instructions
CAUTION: Only use genuine Elite batteries. Use of non-genuine Elite batteries, or batteries that have been
altered, may result in the battery bursting causing fires, personal injury and damage. It will also void the Elite
warranty for the Elite tool and charger.
Tips for maintaining maximum battery life
1. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the
battery cartridge when you notice less tool power.
2. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.
3. Charge the battery cartridge with room temperature at 5 °C - 45 °C . Let a hot battery cartridge cool down
before charging it.
4. When not using the battery cartridge, remove it from the tool or the charger.
5. Charge the battery cartridge if you do not use it for a long period (more than six months).
7
Keep Working