Zanussi ZHRN383K Manual De Instrucciones página 46

Problem
and a number come on.
comes on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
9. TECHNICAL DATA
9.1 Rating plate
Model ZHRN383K
Typ 60 HED D1 KO
Ser.Nr. .................
ZANUSSI
9.2 Cooking zones specification
Cooking zone
Middle front
Middle rear
For optimal cooking results use cookware no
larger than the diameter of the cooking zone.
46 ENGLISH
Possible cause
There is an error in the hob.
The second phase of the power sup‐
ply is missing.
PNC 949 492 571 00
220 - 240 V, 50 / 60 Hz
Made in: Romania
2.9 kW
Nominal Power (Max heat set‐
ting) [W]
1200
700 / 1700
Remedy
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Check if the hob is correctly connected
to the electrical supply. Remove the
fuse, wait one minute, and insert the
fuse again.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
Cooking zone diameter [mm]
145
120 / 180
comes