Publicidad
Idiomas disponibles
Idiomas disponibles
MAX
2 pz/pcs.
Fig. 3
and carefully wipe dry; do not use abrasive detergents or powders for cleaning.
ELECTRICAL CONNECTION
Before carrying out the electrical connection, check that the voltage
and frequency on the appliance rating plate correspond to those of the
mains supply.
A suitable circuit breaker, with a gap of at least 3 mm between the con-
tacts, should be installed between the mains and the appliance.
The appliance must be connected to an efficient earthing system. The
appliance must also be included in an efficient equipotential system that
conforms to the standards in force.
Failure to comply with these safety rules and regulations will relieve
the manufacturer of all liability.
ADJUSTMENT OF FEET
The feet can slide as you like along the long sides in order to facilitate
installation if there are obstacles such as drains, plinths, and so forth). To
do so, loosen the bolts, slide the feet along the long sides to the desired
position and secure them with the bolts.
STORAGE OF THE APPLIANCE
The machine must be stored in a dry humidity free environment. Before
storing the machine, it must be protected from dust or other debris with a
tarp.
IMPORTANT ! !
When storing the appliance (only for packing in crates) do not stack more
than two crates (Fig. 3).
Place the appliance far from possible draughts (doors, windows, air-condi-
tioning outlets, etc.), and leave at least a 100 mm gap between the appli-
ance and the wall or any other object that could prevent correct circulation
of air around the actual appliance. Room temperature should not exceed
the established temperature limits for the class of appliance (25° C - 60%
humidity); appliance performance may be affected should these conditions
be exceeded.
Slowly remove the protective film from the steel, without tearing it in order
to avoid glue remaining on the surface.
Should this happen, remove the glue using a suitable solvent. Clean the ap-
pliance and accessories with lukewarm water and neutral soap, then rinse
1
Fig.5
15
25°C
60%
2
Fig. 4
Publicidad
