Kinderkraft NESTE GROW Manual De Uso página 40

• Be aware of the risk of open fire and other sources of strong
heat, such as electric bar fires, gas fires, etc. in the near
vicinity of the cot (crib and suspended bed).
1. List of parts
1A. Side frame x2
1B. Main frame of the cot
2. Side frame
3. Cot material
4. Center support holding the bottom
5. Side bracket in the cot padding
6. Bottom board of a crib
2. Assembly of a crib <90cm (fig. AE)
Prepare a suitable surface, not to damage the product during assembly. Connect the side frames
(1A) with the main frame (1B) of the cot, you'll hear a "click" if it's assembled correctly (figure
A). Slide the material (2) onto the exposed areas of the side frame (figure B). If necessary, slide
the fabric a little more off the main frame. Then slide material onto the tube to the end of the
main frame and close the zipper (fig. C). ATTENTION! Remember to secure the zipper before
opening (fig. D). Connect the drop side tube to the upper part of the frame (fig. E) and secure
the zipper on both ends (fig. F). ATTENTION! Remember to secure the zippers before opening.
Then connect the two ends of the crossbar (3) to the legs of the cot by sliding them into the
corresponding holes on both sides (fig. G). Correct assembly is characterised by a click. Slide the
central support that holds the bottom (4) into the holes located on both legs, in their centre
(fig. H). The tabs in the middle of the centre support (4) should be on the upper side of the
support. Correct assembly is characterised by a click. Wrap the hook and loop fasteners on the
sides of the cover around the bars on the legs of the cot (fig. I). Slide the ends of the side bracket
(5) in the cot padding material into the relevant openings in both side frames (figure J). Correct
assembly is characterised by a click (fig. K). There is a mattress extension (9) in a pocket under
the bottom of the cot - pull it out for the use of the cot. Note: Keep this item for cot assembly
>90 cm, for older children. Connect the two fabric straps on the sides of the cot with the hook
and loop fasteners under the bottom (fig. L). Insert the baseboard of the cot (6) (without
additional extension (8)) and press the plastic handles into the central support (4) (through the
correctly positioned holes in the base of the cot cover). Place the mattress (7) on the base plate
(without additional extension (9)).
7. Mattress with sheet
8. Extension of a bottom board
9. Extension of a mattress
10. Fixing straps
11. Bag
12. Screwdriver
40