Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan
1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 6. (Figure 1)
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3.
Route the black, white and blue wires through
the downrod. (Figure 3)
4.
Thread downrod into the downrod support on top
of the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with locking nuts in the downrod support.
(Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
Downrod
Hanger Ball
Hairpin Clip
Downrod
Set Screws and
Locking Nuts (2)
9
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Black, White and
Blue wires
Downrod
Figure 3
Hairpin Clip
Clevis Pin
Figure 4
Publicidad
