Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING, MAINTENANCE AND TRANSPORT
Cleaning of your device is composed of two stages, which are the internal cleaning and external
•
cleaning.
Following warnings must certainly be abided before start cleaning.
•
CAUTION!
Unplug your product before every cleaning.
•
Always wear protective gloves during cleaning and maintenance. This will protect you from
•
injuries.
Never use domestic cleaning agents, abrasive and scratching substances (surface cleaners,
•
detergent, flammable and sparkling, solvent like gasoline, thinner, acid) as cleaning agents.
Otherwise loosening may occur in the plastic parts of your product.
Never use flowing and pressurized water for cleaning.
•
INTERNAL CLEANING
Transfer the bottles inside your product to a convenient place.
•
Before the internal cleaning, wait until the temperatures of the internal parts of your product
•
reaches to the ambient temperature.
Always wear protective gloves during cleaning and maintenance. This will protect you from
•
injuries.
Remove the accessories from inside.
•
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning agents
•
recommended.
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
•
Make sure that no wet or humid area is left in the internal section after cleaning.
•
You can reload your product three hours after running your product as stated in this manual.
•
EXTERNAL CLEANING
Clean with a cotton cloth and warm soapy water.
•
Prevent penetration of cleaning water into the front control panel and lighting section while
•
cleaning.
Clean the door gasket by using clean soapy water only.
•
MAINTENANCE
Clean the dust accumulated on the condenser, which is on the back part of your device with the
•
help of a vacuum cleaner or a dry brush after unplugging the device. Repeat this process a few
times in a year.
52
Publicidad
