Descargar Imprimir esta página

Jocel JAG003447 Manual De Instrucciones página 55

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
The beverage cooler is
not working. (No sound
or only fan sound
comes from the
product.)
The product internal
temperature is high.
The product internal
temperature is very low.
Lamp of the cooler do
not light
High degree of
sweating on the glass
and inside the device.
The power values of the lamps and LEDs used in your products are indicated in the section where
they are inserted and may vary depending on the product. Only an accredited technician can replace
lamps and LEDs used in your product.
Setting the digital thermostat values other than the factory settings are completely under the user's
responsibility. JOCEL shall not be held responsible for the material and moral losses that may arise
in connection there to.
POSSIBLE SOLUTION
It may be due to the
thermostat not plugged in.
The fuse may be blown or
broken down.
The condenser grids may be
obstructed or get dirty.
External ambient temperature
is very high or it's with the
wrong thermostat setting.
The ventilation grids (very
close to the back wall) are
obstructed or blocked by an
object.
It may have been expose to
excessive external wind.
The Condenser grids are very
dirty.
Wrong internal thermostat
setting.
Lamp are turned off.
Lamp has blown or starter
failure.
Water discharge hole may be
obstructed when sweating is
seen inside the beverage
cooler.
In glass sweating on the
other hand, current external
ambient humidity is over
65%.
It will run again when
reached to the suitable
temperature.
Insert the plug properly.
Consult to the JOCEL
Technical Assistance.
Clean the condenser grid.
Move the beverage
cooler to a place where
the external temperature
is lower.
Adjust the temperature,
like the recommended.
Clean in front of the
ventilation grids.
Prevent the wind.
Clean the condenser
grids.
Re-set the thermostat.
Turn-on the lamps.
Replace failed part.
Clean water discharge hole.
With regards to the high
humidity, you can move
your beverage cooler to an
environment with less
humidity.
54
RESULT

Publicidad

loading