Kero-Sun LC 3000 Instrucciones De Uso página 19

E
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted, when the heater is burning. Use
the adjustment keys
keys to switch on the function (the °C mark ¸ will start blinking). Next, adjust the
temperature using the key on the right ( min.) to set the temperature to a higher
setting and the key on the left ( hour) to lower the temperature. Press once to
increase the value one step. After approximately 10 seconds the °C mark will stop
blinking and the setting will be locked (Fig. G).
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
F
USING THE TIMER
The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) and the heater should be off. Follow the procedure below:
1 Press the button ¹ and then the TIMER key
The TIMER lamp
2 Use the adjustment keys
Use the key on the left (
( min.) to set the minutes (interval of 5 minutes).
3 After approximately 10 seconds the 4-digit will show CLOCK again and the
TIMER lamp
activated (Fig. H).
4 The timer will ensure that the room will have been heated to approximately
the required temperature at the set time.
When you want to switch off the heater and ignite it again with the timer, all
!
you have to do is press the TIMER key (refer to Section G).
Press the button ¹ once to clear the timer setting.
G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater:
1 Press the button ¹. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
2 Press the TIMER key
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function. You can change the required time with
the adjustment keys
to adjust the temperature. First press either of the two
and the 4-digit ¸ will start blinking.
to set the time at which the heater must ignite.
hour) to set the hours and the key on the right
will light up, indicating that the timer function has been
, when you want to switch off the heater and ignite it
(refer to Section F).
immediately after that.
H: The TIMER indicator
light indicates that the
timer function has been
switched on.
4
7