Installation
Power Wiring
1. Disconnect the battery to avoid an electrical short.
2. Connect the ground wire to the GND terminal of
the Quick-Connect Power Plug.
3. Run power wire to the battery.
4. Install a 2A fuse within 7" (18cm) of the battery
and in-line with the power cable connected to your
amplifier. Use only KICKER KMPK Wiring Kits or other
genuine KICKER marine accessories when installing
in marine applications.
5. Connect the power wire to the +12V Constant
terminal of the Quick-Connect Power Plug.
6. Connect the remote wire from your source unit to
the REM IN terminal of the Quick-Connect Power
Plug.
+12V
REM IN
REM OUT
GND
Constant
English
5