Stop & Go 8PLUS-MINUS CLIP Instrucciones De Instalación página 10

Prior to
Installati on
EN
installati on
Aft er installing the control device including the speaker housing, laying the high-voltage cable and att aching the stainless
steel contact plates, the setup should be retested to ensure that it functi ons correctly. Since the integrated sensor auto-
mati cally switches off the device if the vehicle is in use, you must ensure that the car is moti onless before performing a
functi on check using a multi meter. Set "direct current – 300 V" and measure the voltage between the two stainless steel
contact plates (should read 250–300 V). If the functi on check is successful but voltage fails to build up aft er installati on,
an installati on error has occurred.
Regular green blinking (approx. every 5 seconds) = OK: ultrasound is being emitt ed, high voltage has built up.
Rapid green blinking = voltage is building up/dissipati ng. Cauti on: residual voltage!
LED off = device is switched off .
Red LED = batt ery voltage too low. Change of batt ery required.
Prior to
Installati on
installati on
1. Do the butt on batt eries (CR2477) have a voltage of at least 3 V? Regular testi ng of the batt ery voltage
is recommended.
2. Is the engine switched off ?
3. Have all the plus stainless steel contact plates been installed so that they do not touch any other live
or earthed parts (risk of short circuit)?
4. Is the device completely sti ll and not subject to any movement or vibrati on?
5. Has the positi on of the stainless steel contact plates on the cable been changed, damaging the copper core?
Prior to
Installati on
installati on
*Switching the device on and off
Pull the slide contact (printed part)
half way out.
Changing the CR2477 batt ery
Pull the slide contact (printed part) out completely. When inserti ng the batt eries, pay att enti on to the polarity. The printed plus side of the batt ery should face
upwards so that the plus sign is visible aft er inserti on of the butt on batt ery. Push the slide contact back in, keeping it straight!
10
Trouble
Functi on
check shooti ng
Functi on Trouble
check shooti ng
Functi on Trouble
check shooti ng
Function control light (green = sufficient battery voltage, red = change of battery required
CR2477
Minus plate Minus plate
Plus plate Plus plate
(marked with a sticker) (marked with a sticker)
Base Base
Circuit
Warranty
diagram
Circuit
Warranty
diagram
Circuit
Warranty
diagram
Speaker housing
Control device/
slide contact*/
battery compartment
Fastening tunnell Fastening tunnell
Hinge
Slide out pin with suitable
device to open the hinge
Guide steps
Cable wall
Fastening tunnell Fastening tunnell