Publicidad
Do not unplug by pulling on the cord, use cord as a handle, close a door on cord, or pull cord
around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated
surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Turn o all controls before unplugging.
To Reduce the Risk of Fire and Electric Shock due to internal component damage, use only
NARWAL cleaning fluid intended for use with this appliance. See the Cleaning Fluid section of
this manual.
Place the cords from other appliances out of the area to be cleaned.
Do not operate the vacuum in an area where there are lit candles or fragile objects on the
floor to be cleaned.
Do not allow children to sit on the vacuum.
Recharge only with the charger specified by the manufacturer. A charger that is suitable for
one type of ba ery pack may create a risk of fire when used with another ba ery pack.
Under abusive conditions, liquid may be ejected from the ba ery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts the eyes, additionally seek medical help.
Liquid ejected from the ba ery may cause irritation or burns.
Do not use a ba ery pack or appliance that is damaged or modified. Damaged or modified
ba eries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
Do not expose an appliance to fire or excessive temperature.
Follow all charging instructions and do not charge the ba ery pack or appliance outside of
the temperature range specified in the instructions. Charging improperly or at temperatures
outside of the specified range may damage the ba ery and increase the risk of fire.
Only used with base station (Model: YJCB012) for charging the application.
Do not use and store your robot in extremely hot or cold environments. Do not operate your
robot below 0°C/32°F or above 35°C/95°F. Do not store your robot below -20C/-4°F or above
70°C/158°F. Charge your robot at a temperature between 5°C/41°F and 30C/86°F. Keep your
robot away from fire or places with temperatures higher than 130°C/266°F. Otherwise, your
robot may explode.
the
stepping
operating
the
cli edge
scrap
33
Publicidad
