Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
NOZZLE MAINTENANCE
SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, clear them from the
brushroll.
CLEANING THE SOFT ROLLER
Slide the Soft Roller access button forward
to release the Soft Roller.
CORD MAINTENANCE
To minimize the risk of power cord damage,
DO NOT run the vacuum over the power cord.
If this occurs, immediately shut off power to
the vacuum and remove the cord from the
brushroll or nozzle.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed. Use
only water, and allow it to air-dry completely
for at least 24 hours. Reinsert the Soft Roller
in the front of the nozzle until it clicks into
place.
1.
DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2.
DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3.
DO NOT close the door on the cord.
4.
DO NOT pull the cord around sharp
corners.
5.
DO NOT leave the cord near heated
surfaces.
CHECKING FOR BLOCKAGES
HOSE BLOCKAGE
Detach hose from vacuum pod, and check
hose and opening on back of pod for
blockages.
NOZZLE BLOCKAGE
Detach wand from floor nozzle, tilt nozzle
neck back, and check opening for blockages.
NOZZLE HOSE BLOCKAGE
To access the nozzle hose, pinch the release
touchpoints on the bottom of the nozzle,
then lift the cover and clear any blockages.
WAND BLOCKAGE
Detach wand from floor nozzle and handle,
and check both ends for blockages.
HANDLE/HOSE BLOCKAGE
Detach handle from wand and hose from
the vacuum pod, and check openings for
blockages.
s h a r kc l e a n . c o m
Publicidad
