Publicidad
Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector on the system board.
2. Insert the solid-state drive at a 45-degree angle into the solid-state drive connector.
3. Replace the screw (M2x3.5) that secures the M.2 2230 PCIe solid-state drive to the system board.
Next steps
1. Install the
hard-drive
assembly.
2. Install the
front
bezel.
3. Install the
side
cover.
4. Follow the procedure in
Removing the M.2 2280 PCIe solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
hard-drive
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
after working inside your
computer.
before working inside your
assembly.
computer.
Desmontaje y reensamblaje
27
Publicidad
