Part 9
OPERATING YOUR DRYER
4. To use a sensor dry cycle
• Select a Manual Dry Cycle.
• Press MORE TIME or LESS TIME until the
desired drying time is displayed. Tap MORE TIME
or LESS TIME and the time will change by 1
minute interval.
Note
The MORE TIME or LESS TIME feature can be used
with Manual Dry, Time Dry and Rack Dry Cycles.
• Press TEMP. CONTROL until the desired
temperature indicator glows.
• (OPTIONAL STEP) If desired, select OPTIONS.
For more details, see Options.
• Press START/PAUSE. Be sure the door is closed.
• If you do not press START/PAUSE within 10
minutes of selecting the cycle, the dryer
automatically shuts off.
• If you wish to end your drying cycle after pressing
START/PAUSE, press START/PAUSE again.
To stop your dryer at any time
Press START/PAUSE or open the door.
Maintenance
Clean lint filter
Clean the lint filter after each use and check it
before use. Not cleaning or emptying the filter
will increase drying time and energy
consumption, therefore dryer life expectancy
could be shortened after all.
I Clean the door and its opening
1. Wipe out the door
opening. Otherwise,
build-ups of dirty and
foreign objects will
damage sealing of
door.
2. Clean the transparent
glass door to keep
inside view clear
through the glass.
2 8
5. Pausing or restarting To pause the dryer at
any time
Open the door or press START/PAUSE once.
To restart the dryer
Close the door. Press START/PAUSE.
Note
Drying will continue from where the cycle
was interrupted if you close the door and press
START within 10 minutes. If the cycle is
interrupted for more than 10 minutes, the dryer
will shut off. Select new cycle settings before
restarting the dryer.
!
Improper wire connection or related wiring error
will can cause fire or electric shock or death.
1.Open the door
and pull the filter
straight up
2.Clean the filter using one of following ways in cases.
Run the fingers
across the filter
Vacuum the lint filter
Wash the lint
screen in warm,
soapy water.
Dry thoroughly and
replace.
WARNING!