CBX ETU PLUS Manual Del Usuario página 9

Unlock the storage latch. Pull the stroller on the handlebar in upright position.
1
Check to make sure the stroller is locked in the fully open position before using it. You hear a click
2
sound if it is done the right way. To attach front wheels, push wheel onto front leg tube until it
clicks into place. Repeat on the other side.
Pull on wheels to make sure both of them are attached.
Use the velcro to fix the canopy softgoods final to the seatunit.
3
In order to losen the hood, take the same steps the other way around.
To open or close canopy, push to the front or the rear of the stroller.
4
To lock the brake please step on pedal and puch it down like shown in the picture. When the
5
brake is locked you hear a click sound. To unlock it push the brake pedal in in upward position.
In order to widen the canopy open the zip for extension. The canopy is in XL mode with mesh
6
window opened.
Front wheels have a swivel lock function (b). To lock the wheels, move the small pin upwards in
7
direction to the frame. To unlock it the other way around.
Both wheels can be removed easily with the push of a button. The front wheels (a) have a small
metal button located at the inner base of the wheel and the rear wheels (c) have a button located
on the bottom of the wheel base. Push button and pull on wheel to remove.
To install the bumper bar, plug the ends of the bar into the holes on the frame like shown in the
8
drawing. Push until you hear a click sound. To remove the bumper bar push the buttons on the
left and right side where the bumper bar attached and pull on the bar.
To recline seat unit, squeeze button and pull the recline strap down until the end of the strap.
9
Push the backpart of the seat down, seat will be in full recline position (a).
To place the seatunit in upright position, squeeze button and push it the whole strap upwards.
To adjust legrest, push the small buttons inside the softgoods on each side. Pull it up until it clicks
10
into place. To lower legrest, push the buttons again and rotate the footrest down.
In order to fold the stroller, push both buttons on handle bar. First the small one, after the bigger
11
one. Lift the stroller slightly on the handle bar and move it forward. The stroller will collaps.
Move the handelbar around and fit it in position. The stroller is compact folded. Storage latch is
12
automatically engaged when folded.
Use the attached handle for carrying. The stroller is overheadcompartment size when folded.
13
To unlock harness, push the button on the crotch buckle then slide the shoulder straps off the
14
waist buckles. To attach the harness and waist straps to the crotch buckle, slide shoulder straps
onto the waist buckles as shown, then click them into the crotch buckle.
Make sure shoulderpads are in right position over your childs shoulders. To adjust harness around
15
your child, tighten shoulder and waist straps by pulling on the free end of the straps as shown.
Important — Keep these instructions for future reference.
Warnings, safety instructions, maintenance, disposal and guarantee can be found in the warnings
booklet.
INSTRUCTIONS
EN
9