Filter Inspection & Cleaning; Oil Change; Belt Adjustment; Tank Inspection - Ingersoll Rand TS4 Manual Del Propietario Con La Lista De Piezas

EN
FILTER INSPECTION & CLEANING

1. Unscrew and remove the wing nut (A) securing the filter housing
(B) to its base (C).
2. Remove the filter housing and withdraw the old filter element(D).
Clean the element with a jet of air or vacuum.
. Replace the filter element and housing, securing it in place with
the wing nut previously removed.

OIL CHANGE


1. Remove the oil drain plug (A) and allow the lubricant to drain into
a suitable container.
2. Replace the oil drain plug.
. Follow the filling procedures in OPERATION section.

BELT ADJUSTMENT


• CHECKING BELT TENSION
Check belt tension should be occasionally, especially if looseness is
suspected. New belts must also be properly tensioned upon installation.
• TENSIONING BELTS
Belt tensioning can be achieved by loosening the motor anchor screws,
pushing the motor away from the pump, and retightening the motor
anchor screws. The motor can be easily moved by placing a prying tool
beneath it. A commercially available spreader or other belt tensioning
device can also be helpful.
Follow the procedures outlined below to correctly set and measure belt
tension. Refer to the following illustration for a visual representation.
EN-10
RELEASED 14/Mar/2018 13:53:20 GMT
1.
2.
Ensure the pulley and sheave are properly aligned and the motor anchor
screws are adequately retightened prior to restarting the compressor.
Improper pulley/sheave alignment and belt tension can result in
motor overload, excessive vibration, and premature belt and/or
bearing failure��
To prevent these problems from occurring, ensure the pulley and sheave
are aligned and belt tension is satisfactory after installing new belts or
tensioning existing belts.

TANK INSPECTION


The life of an air receiver tank is dependent upon several factors including,
but not limited to, operating conditions, ambient environments, and
the level of maintenance. The exact effect of these factors on tank
life is difficult to predict; therefore, Ingersoll-Rand recommends that
you schedule a certified tank inspection within the first five years of
compressor service. To arrange a tank inspection, contact Ingersoll Rand.
If the tank has not been inspected within the first 10 years of compressor
service, the receiver must be taken out of service until it has passed
inspection. Tanks that fail to meet requirements must be replaced.
Failure to replace a rusted air receiver tank could result in air
receiver tank rupture or explosion, which could cause substantial
property damage, severe personal injury, or death�� Never modify
or repair tank�� Obtain replacement from service center��
Lay a straight edge across the top outer surface of the belt drive from
pulley to sheave.
At the center of the span, perpendicular to the belt, apply pressure
to the outer surface of the belt with a tension gauge. Force the
belt to the deflection indicated in the BELT TENSION TABLE in the
DIAGRAMS & TABLES section. Compare the reading on the tension
gauge to the table.
CAUTION
WARNING
22207666 Rev. C