Home Decorators Collection 899-246 Manual De Instrucciones página 7

INSTALLATION & ASSEMBLY (cont.):
9. Slide the Glass Shade into the Cage (Fig. 3).
10. Place the Hood onto the Cage. Simultaneously pull the wires
from the back of the Wall Plate. Align the holes of the Hood
with the holes of the Cage. First, screw a Hood Screw into
the threaded hole of the Hood, then into the threaded hole of
the Cage. Finally, slide the remaining Hood Screw into the
non-threaded hole of the Hood, then screw it into the
threaded hole of the Cage (Fig. 3).
11. Using an exterior rubber sealant, caulk around the edge of
the upper 2/3s of the wall plate. Leave the bottom 1/3
unsealed to allow drainage of any water that might leak into
the enclosure.
Wall Plate
Hood Screw
Hood
Glass Shade
Cage
Fig. 3
Page 7