Xiaomi Smart Cooking Robot Manual De Usuario página 19

página de 146

/ 146
Marcadores

Idiomas disponibles

Fault Codes

If the cooking robot is not working properly, the screen will show an error code. Please refer to the table below to nd the

corresponding solutions.

Fault Codes

The pot lid is

not detected.

The pot is not

detected.

E-03

E-04

E-05

E-07

E-8

E-10

E-11

E-12

E-13

E-16

E-17

E-18

E-19

E-20

E-21

E-22

E-23

Possible Causes

The pot lid is not put or locked in place.

The pot is not installed or is installed incorrectly.

The overvoltage protection is triggered.

High-temperature alert is triggered by

the sensor at the pot boom.

The IGBT temperature is too high.

The IGBT sensor is damaged.

The sensor at pot boom is damaged.

Heating communication has an error.

The coil plate has an open circuit.

The pot is not locked in place.

The motor overcurrent protection is triggered.

The motor high-voltage protection is triggered.

The motor low-voltage protection is triggered.

The motor phase loss protection is triggered.

The motor jam protection is triggered.

The motor temperature is too high.

The motor sensor has an open circuit.

The motor sensor has a short circuit.

Solutions

Put the pot lid in place and press rmly,

then try again.

Align the pot to the correct position and

install it, then try again.

The cooking robot will automatically

resume working when the voltage goes

back to normal.

The cooking robot will automatically

resume working when the voltage goes

back to normal.

The cooking robot will automatically

resume working when the temperature

goes down.

The cooking robot will automatically

resume working when the temperature

goes down.