Remove The Battery Pack; Install The Grinding Wheel; Install The Auxiliary Handle; Operation - GreenWorks AGG302 Manual Del Operador

WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
6.3

REMOVE THE BATTERY PACK

Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
6.4

INSTALL THE GRINDING WHEEL

Figure 4.
CAUTION
Do not attach a wood cutting balde or carving blade to
the machine. It is used to grind and sand materials.
Use for other intentions is not recommended and
makes a risk.
WARNING
Examine a new grinding wheel before you install it.
• Use a wooden hammer to tap around the wheel.
• Listen to the result sounds. Fissures or cracks
result in a different sound.
Do not use a wheel with fissures or cracks. When you
install a new grinding wheel, do a no-load revolution
test of 1 minute with the grinding wheel at a safe
direction.
1. Push the spindle lock button.
2. Engage the flats on the bottom of the disc flange
with the flats on the spindle.
3. Put the grinding wheel on the spindle.
4. Turn the wheel clockwise until the spindle locks in
position.
5. Install the clamp nut on the spindle with the flat side
of the nut up.
6. Install the raised, small diameter piece of the clamp
nut into the hole in the wheel and finger tighten.
7. Tighten the clamp nut.
English
To prevent damage to the spindle or spindle lock, let
motor to come to a complete stop before you engage
spindle lock.
Install a grinding wheel with the center against the disc
flange. Failure to do so can cause the grinding wheel
to break. This can also cuase injury because the loose
particles breaks off and drop down from the grinder.
6.5

INSTALL THE AUXILIARY HANDLE

Figure 5.
The auxiliary handle must be used to help prevent loss
of control and possible injury.
The auxiliary handle can be installed on the left or right
side of the machine.
1. Install the auxiliary handle into the necessary
position.
2. Turn the auxiliary handle clockwise to tighten.
7

OPERATION

Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
7.1

START THE MACHINE

Figure 6.
1. To start the machine, push the On/Off switch
forward.
2. To lock the On/Off switch, push the On/Off switch
down at the front until it latches.
7.2

STOP THE MACHINE

Figure 7.
1. To stop the machine, release the On/Off switch or, if
it is locked, briefly push the rear of the On/Off switch
and then release it.
2. To keep energy, only switch the machine on when
you use it.
7
NOTE
WARNING
WARNING
WARNING
WARNING
EN