Kenmore PowerMate Nozzle Manual De Uso Y Cuidado página 7

CAUTION
Moving parts! To reduce the risk of personal injury, DO NOT
touch the brushroll when vacuum cleaner is on. Contacting
the brushroll while it is rotating can cut, bruise or cause other
injuries. Always turn off and unplug from electrical outlet
before servicing.
Use caution when operating near children.
1. Pull cord out of canister to desired
length. The cord will not rewind until the
cord rewind button is pushed.
2. Plug the polarized power cord into a 120
Volt outlet located near the floor.
3. Lower the wand from upright position by
pressing on the HANDLE RELEASE pedal.
Handle
Release
4. Select a pile height setting by pressing
the height adjust pedal on the rear of
®
the PowerMate
shows on the indicator.
Height
Adjustment
Pedal
OPERATING INSTRUCTIONS
HOW TO START
. The pile height setting
Height
Adjustment Indicator
5. Slide the handle control switch forward
to the CARPET position to start the
PowerMate brushroll spinning.
SUGGESTED PILE HEIGHT SETTINGS
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may
require that they be vacuumed with the
®
PowerMate brushroll turned off to prevent
carpet damage.
For best deep down cleaning, use the
XLO setting. However, you may need to
raise the height to make some jobs easier,
such as scatter rugs and some deep pile
carpets, and to prevent the vacuum cleaner
from shutting off. Suggested settings are:
HI – Shag, deep pile, super-soft, or
ultraplush carpets, and scatter rugs.
MED – Medium to deep pile.
LO – Low to medium pile.
XLO – The preferred setting for many
carpets and also for bare floors.
NOTE:
To protect bare floors, slide the 3-
way On/Off switch to the FLOOR position
to turn off rotation.
CAUTION
DO NOT leave the PowerMate
in one spot for any length of time.
Damage to carpet may occur.
- 7 -
®
running