Bosch TDI 902431E Instrucciones De Uso página 16

Before using your appliance for the
first time
1. Remove any labels or protective covering
from the soleplate (13).
2. If necessary, carefully clean the soleplate
down with a dry, folded cotton cloth.
When turned on for the first time, your new iron
may smell and emit a little smoke and a few
particles; this will stop after a few minutes.
☞
Tip: When using the steam function for the
first time, do not use it on your laundry, as
there may still be some residue in the
steam dispenser.
Hold the iron horizontally and repeatedly
press the shot of steam button (7). Some
residue may come out of the soleplate.
Using your appliance
1. Filling the water tank

See the leaflet sides
This appliance has been designed to use normal
tap water.
• The addition of other liquids, (unless
recommended by Bosch) such as perfume,
will damage the appliance.
• Do not use condensation water from tumble
dryers, air conditioning systems or similar.
Any damage caused by the use of the
aforementioned products will make the
guarantee void.
E
Unplug the iron from the mains!
1. Open the water inlet lid (9).
2. Fill the water tank. Never fill beyond the
level mark for maximum filling (12).
3. Close the water inlet lid.
☞
Tip: To prolong the optimum steam
function, you may mix tap water with
distilled water 1:1. If the tap water in your
district is very hard, mix tap water with
distilled water 1:2. You can inquire about
the water hardness with your local water
supplier.
16
B O SC H
2. "SensorSteam" function

See the leaflet sides
The "SensorSteam" function makes the iron
heat up only when the handle is gripped, and
stop heating when the handle is no longer
gripped.
This function controls the continuous steam
generation as well (see section 5.1). While the
handle is gripped, steam is generated
automatically. When released, steam generation
is stopped.
Thus, safety and saving energy get increased.
1. Plug in the iron.
2. "SensorSteam" lamp (3) flashes when
the handle is not gripped, and will show a
continuous light when the handle is gripped.
3. If the iron handle is released for more
than 10 seconds, the iron will stop heating
automatically.
4. When the handle is gripped again, the iron
heating up and continuous steam generation
processes will start again.
Initial heating up process: it is not necessary
to grip the handle until the iron heats up to the
set temperature.
Once reached such temperature, the "TempOK"
indicator will stop flashing and remain lit
continuously.
The "eco" steam mode is automatically selected.
3. Setting the temperature

See the leaflet sides
The temperature control (15) adjusts the
temperature of the soleplate (13).
1. Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature in the label
on the garment.
2. Set the temperature control (15) to the
corresponding position by lining it up with the
temperature index (14) on the iron.
* Model dependent