Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Fan Blades (continued)
2
Attaching the fan blades
□
Mount the fan blades (H) to the blade bracket (I) by aligning
the three key-slot holes in the blade (H) with the three posts
on the top of the blade brackets (I).
□
Hold the blade (H) close to the blade bracket (I) and press
the blade (H) down firmly. Ensure the key-slot holes are
properly seated on the blade arm posts.
□
While still holding the blade (H) down, firmly slide the blade
(H) away from the bracket(I) side until the blade (H) engages
in the locking mechanism .
□
Make sure the locking mechanism at the rear of the blade
bracket (I) springs upward and butts against the edge of the
blade (H) indicating a secure connection.
□
Visually inspect the top of the blade bracket (I) to ensure the
locking mechanism is securely in place.
□
Repeat for the remaining blades (H).
Assembly - Attaching the Switch Cup Cover
1
Attaching the switch cup cover
NOTE: Notice the location of the fan's reverse slide switch. This
is the switch used to change the fan's directional rotation. For
more information on the operation of this switch, see Operating
Your Fan on page 12.
□
Remove the three screws (QQ) from the switch cup cover (G)
and save them.
□
Align the three holes in the switch cup below the fan motor
assembly with the three holes in the switch cup cover (G). Make
sure the notch the in switch cup cover (G) clears the reversing
switch in the switch cup.
□
Position the switch cup cover (G) and re-install the three screws
that were removed in the first step to secure the switch cup
cover (G).
□
Attach the pull chain extension (AA) to the fan pull chain.
H
I
11
Please contact 1-855-HD-HAMPTON for further assistance.
G
AA
HAMPTONBAY.COM
QQ
Publicidad
