Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
7
Installing the plaster guard
and cartridge
□
Install the o-rings (1) and cartridge (2) onto the
valve body (D). Make sure the cartridge (2) is
installed correctly. Slide the bonnet (3) over the
cartridge (2) and thread them onto the valve
body (D). Tighten bonnet (3) securely with
adjustable wrench until the o-ring (1) on the
valve body (D) is covered completely.
□
Place the plaster guard (I) onto the valve
body (D) and secure with the screws (H).
NOTE: Be sure to position the plaster guard (I) correctly
onto the valve body (D), with the side marked "SHOWER"
facing upward.
3
I
H
1
2
8
Installing the tub spout
□
The tub spout outlet pipe should project
2 1/2 in. to 3 in.
□
Place the spout (K) onto quick connection until
the spout (K) becomes ush with the nished
wall and tighten the screw (1) with the Hex
wrench (Hex: 2.5mm, L) provided.
NOTE:
Use emery paper to remove burrs. Clean debris.
K
11
Please contact 1-855-HD-GLACIER for further assistance.
from the nished wall.
1
L
2-1/2 in. to 3 in.
Wall
HOMEDEPOT.COM/GLACIERBAY
Publicidad
