EuroLite TB-3 DMX-Roller Manual Del Usuario página 21

DMX-512 connection / connection between fixtures
Projector 3
Starting address 9
LIGHTING CONTROL
PROTOCOL DMX-512
120 Ohms
DMX Out
XLR occupation:
1: Ground
2: Signal (–)
3: Signal (+)
DMX In
For setting the DMX
Blackout starting address see
projector head.
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Addressing
Each projector occupies 4 channels. To ensure that the control signals are properly directed to each
projector, the projector requires adressing. This is to be done for every single projector by changing the DIP
switches as set out in this table.
The starting address is defined as the first channel from which the TB-3 will respond to the controller. If you
set, for example, the address to channel 5, the TB-3 will use the channel 5 to 8 for control.
Please make sure that you don't have any overlapping channels in order to control each TB-3 correctly and
independently from any other fixture on the DMX data link. If two, three or more TB-3 are addressed
similarly, they will work similarly.
All manuals and user guides at all-guides.com
Microphone
Sensitivity
Fuse: T 2 A, 250 V
Power supply:
230 V AC, 50 Hz ~
Blackout
Projector 2
Starting address 5
LIGHTING CONTROL
PROTOCOL DMX-512
Microphone
Sensitivity
DMX Out
XLR occupation:
1: Ground
2: Signal (–)
Fuse: T 2 A, 250 V
3: Signal (+)
DMX In
Power supply:
230 V AC, 50 Hz ~
For setting the DMX
starting address see
projector head.
DMX-512 Controller
21
Projector 1
Starting address 1
LIGHTING CONTROL
PROTOCOL DMX-512
Microphone
Sensitivity
DMX Out
XLR occupation:
1: Ground
2: Signal (–)
Fuse: T 2 A, 250 V
3: Signal (+)
DMX In
Power supply:
230 V AC, 50 Hz ~
For setting the DMX
Blackout starting address see
projector head.
Ω
resistor