Setup; Installation; Sound-Control - Futurelight CP-240 Manual Del Usuario

11) SPEED-FADER
12) FADE TIME-FADER
13) DISPLAY
14) MIDI/REC-BUTTON
15) FINE-BUTTON
16) AUTO/DEL-BUTTON
17) MODE-BUTTON
18) MUSIC-LED
19) MANUAL-LED
20) AUTO-LED
21) BANK UP-BUTTON
22) BANK DOWN-BUTTON
23) TAP/DISPLAY-BUTTON
24) BLACKOUT-BUTTON
25) CHASE-BUTTONS
26) PAN-ENCODER
27) TILT-ENCODER
Rear panel:
28) Audio input socket
29) MIDI input socket
30) DMX POLARITY selector
31) DMX output socket
32) DMX input socket
33) Smoke-machine socket
34) Power supply socket
35) Power switch

5. SETUP

5.1 Installation

Install the device on a plane surface or install it in rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

The sound-control works via the built-in microphone or via the sound input socket.
Connect the sound-signal from the mixer (e.g. Master 2) with the RCA-socket on the rear panel (input
sensitivity 0.1 V - 1 V).
17/41 51834265_V_1_2.DOC