Assigning The Fade Time; Invert The Faders; Smoke-Machine; Operation - Futurelight CP-240 Manual Del Usuario

Delete all channel-assigns
Caution: When you select this function, all programmed channel-assign will irrevocably be lost.
Press and hold the Mode-button and the Auto/Del-button while disconnecting the device from the mains.
Connect the device to the mains again.

5.5 Assigning the Fade Time

With this function, you can determine if the Fade Time should be assigned only for the Pan/Tilt movement or
for all DMX-channels. This makes especially sense when the mirror or Moving-Head movement should be
carried out slowly, but the gobos and colours should be changed quickly.
Turn the device off.
Press and hold the Mode and Tap/Display-button at the same time.
Turn the device on again. Press the Tap/Display-button in order to switch between the two modes.
A ll cha nnel s
Press the Mode and Tap/Display-button at the same time in order to memorize your settings. All LEDs on the
panel will flash indicating your settings are saved.

5.6 Invert the faders

With the CP-240, you can invert the faderway of every channel fader.
1) Press the Fine and Mode-buttons, so that the Single/Mix-Chase-LED lights up.
2) Select the desired projector via the projector select buttons.
3) Adjust the Fade Time-Fader in order to select the desired channel fader (1-8, X, Y).
4) Adjust the Speed-fader in order to select Y for inverted or N for not inverted.
5) Press the Rec-button.

5.7. Smoke-machine

Please note: Do only connect low-voltage foggers!
The occupation of the Smoke-machine socket is as follows:

6. OPERATION

After you connected the device to the mains, the CP-240 is ready for use. Switch the device on via the
Power-switch.
A LL CH
F D TIME
O NLY X/Y
OR
FD TIME
O n ly P an/Ti lt
19/41 51834265_V_1_2.DOC