Songmics LSD015 Instrucciones De Montaje página 16

EN
Controller
The whole controller is a button operated panel. If the display is not operated for 30 seconds, the display goes to sleep and is locked and the M1/
M2/M3/M4 cannot be used. You can continue to use the display when it lights up by pressing the " " or " " button.
Up/Down
Drive the desk to the desired height when pressing and holding " " or " " button.
Memory Button
When the desk reaches the height that you want to memorize, press and hold any of the M1/M2/M3/M4 button for 5 seconds. When you hear the
sound "beep", this height is memorized in the corresponding memory button. Recall the stored height by pressing the corresponding button.
Setting Button (M4)
When you need to set the relevant parameters, please press and hold the "M4" button for 10 seconds.
Display Screen
Displays the height value of the desk.
Initialization Settings
Initialization: When the system is abnormal and the display shows "RST", please press the " " button until the product is lowered to the lowest
height and the product bounces back after hearing a "beep" sound, then the initialization is completed. (Tip: In the process of operation, do not
release the button, otherwise the initialization will fail) .
Forced initialization: Please press the " " button until the product drops to the lowest height, then release the button and press the " " button
again for about 5 seconds until you hear a "beep" sound and the product bounces back, then the initialization is completed.
System Reset: When the product is replaced with a new controller or the parameters need to be restored to the factory settings, press the " "
and " " button at the same time, the first "beep" sound will be heard after about 5 seconds, and the second "beep" sound will be heard after 10
↓
seconds. After the display shows "RST", please press the " " button until the product drops to the lowest height, and the product bounces back
after hearing a "beep" sound, then the reset is completed.
Safety Function
The table top will automatically spring back when it encounters reverse resistance during ascent or descent.
Error No. & Solution
Error No.
E01, E06, E07
E04
E05
E08
E11, E21, E40, E41
E12, E22, E42, E43
E14~E17, E24~E27
E18, E28
HOT
16
↓
↓

Description
Power Error
Controller connection error
Reverse run prompt when blocked
Desktop tilting while running
Connection cable failure
Controller failure
Motor failure
Weight overload
Running timeout
↑ ↓
↓
Check the desktop (perform initialization 1)
Check the cable (perform initialization 1)
Remove the items on the desktop (perform initialization 1)
Stop using and resume automatically after 20 minutes
↑ ↓
Solution
Replace power supply
Re-plug the controller cable
Bounce alert, normal
Replace the controller
Replace the motor
↓
↑