UFESA Dakota Manual De Instrucciones página 19

INSTALLATION
• After removing the packing, check the condition of the appliance; if in doubt, do not use
it and take it to a professional, qualified technician. The packaging (plastic bags, polys-
tyrene, fixtures, etc.) should be kept out of the reach of children since they are a potential
source of danger, and they should be disposed of in the appropriate specific containers for
selective waste collection. Warning: any stickers or leaflets attached to the grille must be
removed before using the appliance.
• Before connecting the appliance check that the voltage values indicated on the cha-
racteristics plate correspond to those of the electric mains supply, In the event that the
mains socket and the appliance plug are incompatible have the plug changed to one that
is suitable by a professional, qualified technician, They will check that the cable part of
the plug is adapted to the power used by the appliance. In general, the use of adapters or
extension leads is not advisable' if this is necessary, they must be in accordance with the
safety regulations and their amperage capacity must not be less than the maximum for
the appliance.
• Before each usage, check that the appliance is in good condition and that the power cord
is not damaged: if in doubt, check with a professional, qualified technician.
• The mains socket must be easily accessible in order to disconnect the appliance with
ease in case of emergency.
• Position the appliance away from: sources of heat (e.g. open flames, gas ovens, etc.)
deposits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (minimum
distance 2 met re s) fabrics (curtains, etc.) or loose materials, which may obstruct the ven-
tilation grille; in addition, check that the front part is free of volatile materials (dust, etc.).
• The supporting surface must be stable flat and even (so that the appliance does not tip over).
ASSEMBLY
Warning: the fan may be used only if it is fully and properly assembled, that is to say, com-
plete with the base and the grille.
Warning: always disconnect the appliance from the mains supply before assembling. If in
doubt, have the operation checked or carried out by a qualified technician.
ASSEMBLE OF BASE
• Set the column in place on the base and secure it using the "L" screw with washer while
also engaging the counterweight.
• Make sure column and base and counterweight are firmly coupled.
• Loosen the Height Adjustment Collar on top of the Inner Tube. Pull the Inner Tube out from
the Outer Tube to adjust the tube to the desired height and tighten the collar.
• If necessary, slightly loosen the Set Screw by turning it anticlockwise. Slide the Switch
Box down over the Inner Tube and tighten the Set Screw. Make sure the Set Screw is tightly
secured.
ASSEMBLE OF BLADE AND GRILLE
• Unscrew the plastic mounting nut from the front of the motor housing by rotating it an-
ticlockwise.
• Position the rear grille against the front of the motor housing with the handle uppermost,
19