UFESA Dakota Manual De Instrucciones página 20

ensuing that the locating pegs on the motor housing are engaged correctly in the holes of
the rear grille.
• Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
• Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the
drive pin that passes through the motor shaft.
• Tighten the blade cap by turning it anticlockwise.
• To fasten the front grill, it is best to place the main unit on a smooth even floor. Couple
the front grill to the rear and hold in place with plastic ring, (a fixing screw is good at the
bottom) and secure fastening by tightening screw
• At the end of the operation check that the protective grills are firmly coupled and atta-
ched to the motor.
USE
Before each use check that the appliance is in good condition and that the electric cable
is not damaged; if the electric cable is damaged, it must be replaced by the manufacturer
or by the technical assistance service or in the event, by a qualified technician, in order to
avoid any type of danger.
CONTROL PANEL
A. Power
B. SPEED button
C. MODE button
D. TIMER button
E. SWING button
F. Swing indicator
G. Speed indicators (high-mid-low)
H. Time indicators 0.5-1-2-4 hrs
l. Sleep mode indicator
1. Switch on the appliance by pressing the ON/OFF button (A) on the control panel. The fan
starts to blow at low speed. The low speed indicator (G) lights up,
2. To change speed, press button (B) several times. Speed will change with each button
stroke. The respective indicator (G) will light up.
3. For oscillation, press the SWING button (E). The swing indicator (F) light up and the fan
starts oscillating. To stop oscillation, press button (E)once again,
4. Your fan has a timer function. After having switched the unit on, press the TIMER button
(D) and the fan will operate for as long as you choose: Press the timer button several times
and the setting will
change with every button stroke. The respective indicator lights (H) light up. When the set
time has elapsed, the fan switches off automatically. The fan can set the timer function
from 05-7.5 hours as specified by the sum of the Time Indicators that are lit.
5. The air flow can be adjusted by tilting the entire motor unit upward or downward. Loo-
sen the neck screw (9) and adjust themotor until you have reached the desired vertical
angle. Tighten the screw again.
6. To switch the fan off, press the ON/OFF button (A).
20