Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 030 9904733
- in basement floors, in upper floors or in rooms with a volume less than 15 m 3 ;
- in places with the risk of fire (garage).
4) Do not use the stove in bedroom while sleeping.
5) The heater must not be close to other sources of heat (minimum distance 1 meter), inflammable
materials or explosives and must not be directed towards objects which could be damaged or catch fire
(it must not be directed towards curtains, armchairs and furniture, for example).
6) Face the heater so that the heat is directed towards the centre of the room and towards an open
space; the frontal part (radiating) must be placed at least 2 meters away from curtains, couches,
furniture or other objects. The sides and the rear part of the stove must have a free space of at least
50cm.
Special attention as to be attached if the stove is in a room where children or animals can enter.
For the installation follow norms UNI CIG 7129 and the norms UNI CIG 7131, par. 3.1-3.2-5.4-6.1-
6.2-6.3.
7)
Do not use the stove on the mountain.
8)
Use the stove only with the gas cylinder in its compartment. Use the stove and the gas cylinder
only in vertical position.
9)
Use only 15kg gas cylinder. Check the right gas for your stove.
10) In case of defective functioning or damage, switch the appliance off and let it check by qualified
personnel.
USE (See Fig.4)
Controls for switching on and adjustment are found at the top of the appliance.
1.
Open the cylinder valve.
2.
Press the valve knob down hard and turn anti-clockwise until reaching the ON position
marked "
knob must be pressed for 15 seconds after the flame has lit. If the pilot does not light, repeat
the procedure.
For new installations or when the cylinder is changed, it may be difficult to light the pilot flame: it
does not remain attached to the collar of the pilot but tends to escape and goes out when the valve knob
is released. Repeat the lighting procedure a few times until turbulence (cause of the inconvenience) is
removed, the pilot flame will remain attached to the collar and alight, and the burner will start.
3.
Regulating the heat:
a.
For "minimum" position, press the knob down hard and turn anti-clockwise to the position
marked "
b.
For "medium" position, press the knob part and turn anti-clockwise to the position marked
"
" (see fig. "pos.2").
c.
For "maximum" heat, press the knob down hard and turn anti-clockwise to the position
marked "
d.
To return to medium and minimum settings, press the knob and turn clockwise until reaching
the position required.
4.
To switch off the stove, press the knob and turn clockwise until reaching the OFF position marked
"
": To switch the stove off completely, the cylinder valve must always be shut.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
" (see fig.4 "pos.A"), thus lighting the pilot flame; to keep the flame alight, the
" (see fig. "pos.1").
" (see fig. "pos.3").
11
Assembly page 11/32
32
/
Publicidad
