Publicidad
Idiomas disponibles
Idiomas disponibles
6- Check the Repeater's Operating Status on the display and follow the guidelines below:
1
2
3
1- Indicates the transmission technology in operation 2G, 3G or 4G.
2- Indicates that the A.L.C gain control is activated, it occurs when the input level is greater than -48dBm.
The equipment will be functioning normally but it is recommended that the input level is between -50 to -
70dBm. You can decrease the input level by disappointing the external antenna in relation to your
operator's cell tower.
3- Indicates that the repeater is receiving signal from the cell tower.
4- Indicates the level in dBm received by the external antenna, it is recommended that the level be
between -50 to -70dBm.
5- Indicates the level in bars received by the external antenna, it is recommended to have at least two bars.
6- When the arrows and hyphens remain lit, it indicates that the equipment is well insulated between the
internal and external antennas.
When only the arrows flash, it indicates that the internal and external antennas are reasonably close, the
repeater will work but with low range and possible interference, to improve it is necessary to increase the
distances between the antennas, make sure you have at least 10 meters of distance. insulation between
them and also a barrier, such as wall or slab.
When arrows and hyphens flash, it indicates that the internal and external antenna are very close, in
which case the repeater will automatically turn off to protect itself against a possible circuit burn.
7- Indicates the level in dBm transmitted by the internal antenna.
8- Indicates the level in bars transmitted by the internal antenna.
4
5
6
17
7
8
Publicidad
