Zodiac DF2 Serie Manual De Instalación Y De Uso página 20

3.1.2 Description of the display screen
Symbol Description
On/Off
Air heating optional
Electrical-air heating
kit
Hot water-air heating
kit
Compressor
Fan speed: Active
Fan speed: Normal
Alarm
Defrost
Pool Cover
Filtration pump
Solenoid valve
Time bands
Test mode
3.2 I Operation
3.2.1 Switching on the appliance
• Power on the appliance (by switching on the general terminal board),
• The software version/revision remains visible for 10 seconds then the appliance recovers the last state it was on:
Either switched ON or OFF.
Only for DF2 three phases models:
• This operation must be only be carried out by a qualified professional.
• The phase order controller protects the compressor. It is forbidden to invert phases:
- On the power contactor.
- On the compressor.
The phase error controller is located in the electrical unit, on the right hand side of the appliance.
• When the dehumidifier is switched on, check the status of the phase order controller as shown below:
Indicator light
status
• If there is a phase inversion or missing phase:
1. Disconnect the appliance from the power supply;
2. Invert two phases directly on the appliance connection terminal board;
3. Restore power to the appliance and check the status of the indicator lights.
20
Steady
Appliance switched off
Air heating optional is enabled
Electrical-air heating kit is ON
Hot water-air heating kit is ON
Compressor is ON
Fan is ON at "ECO fan" speed
Fan is ON at nominal speed
Alarm in progress
Defrost in progress
Pool cover is ON
Order to request filtration
pump activation
Solenoid valve ON
Time bands are active
Test mode is ON
OK~
Flashing
/ Appliance in operation
Air heating optional is not
/
enabled
/ Electrical air heating kit is OFF
/ Hot water air heating kit is OFF
Compressor timed Compressor is OFF
Fan timed Fan is OFF
Fan timed Fan is OFF
/ No alarm is present
/
/ No pool cover input
/
/
/
/
OK~
Off
/
/
/
/
/