Vorwerk kobold SPB100 Manual De Instrucciones página 65

Fault
The moisture film is uneven. It is possible that the tank is empty.
The floor is getting too wet.
Possible cause and solutions
– Alternatively, use the MF600/601 Dry cleaning cloth to remove
any residual quantities of old care products and cleaning
agents.
– Repeat the cleaning process, replacing the cloth if necessary,
until you see an improvement.
– If there is no improvement, carry out a thorough clean of the
floor before continuing to work with the DuoClean.
– Check the LED wave symbol on the DuoClean. If it is lit up
yellow, you need to fill the tank, see
inserting the tank
– Moisten the cleaning cloth by pressing the function key before
continuing, see
mode [} 53].
– Set the DuoClean to dry mode, see
moisture and dry mode
– Continue working without the automatic moistening function
for the time being until the floor appears to be drying.
– Then set the DuoClean to moisture setting 1, see
application of moisture and dry mode
If the fault cannot be rectified, please contact Vorwerk customer
service, see Service [} 66].
[} 52].
Automatic application of moisture and dry
Automatic application of
[} 53].
Removing, filling and
Automatic
[} 53].
65