Electronic Control - Indel B TB31 Instrucciones De Uso

ENGLISH
INSTALLATION
- Place the refrigerator on a dry, sheltered, flat surface and away from any edges. The refrigerator must
not be used unsheltered, in the open air or exposed to splashing or rain.
- Your refrigerator requires good ventilation, especially around the back of the refrigerator, allow a gap of
at least 15 cm around the sides, back and top. Never use your refrigerator in the boot of a car or against.
- Do not install the refrigerator near heat sources, sunlight.
- Should you need to leave the device under the sun for long periods, eg. in a car or in other vehicles,
make sure you protect it, to prevent the cover plastic materials from getting damaged or warped.
- To fix it inside the car and to avoid damages during transport, we suggest to secure the fridge trough
metal brackets placed on the sides.
- Avoid introducing liquids or ice not inserted in containers.
- Do not put hot food items into the refrigerator.
- Avoid using the refrigerator under the rain or in presence of water.
USING THE REFRIGERATOR IN A VEHICLE
- Connect the feeding cable to a direct current 12 or 24 V DC power source.
- Make sure the polarity is right.
- The supply line is protected by a 15 A fuse located on the box.
- If connected to an existing cigarette plug, carefully check up that power supply is sufficient.
- If the supplied power cable is not used, see the table containing the information related to the cable
section:
CABLE AREA
2,5 (AWG 13)
4 (AWG 11)
6 (AWG 9)
8
TB31-TB41
MAX CABLE LENGHT METRES (ft)
12V 24V
2,5 (8 FT) 5 (16FT)
4 (13 FT) 8 (26 FT)
6 (20 FT) 12 (40 FT)
TB 31-41_06-03-2017
TB31-TB41

ELECTRONIC CONTROL

Compressor station
Functions and features.
This is an electronic device which has the function of piloting the motor of the compressor and carrying
out all the controls and electrical protection of the system.
Its main features are as follows:
a) Protection of the battery through automatic turning off of the compressor when the feeding voltage
reaches the minimum threshold.
The compressor will start up again automatically when the voltage goes back to normal values.
Note: these values have been measured at control unit input and/or on the DC socket.
BATTERY PROTECTION LEVEL
It is possible to set three different battery protection threshold levels:
Battery protection Display
MIN. 1 Bar
MED.
2 Bars
MAX.
3 Bars
To enter the menu, switch the refrigerator on by pressing the ON/OFF button.
Press and hold the SET + ON/OFF buttons at the same time for several seconds to access the battery
protection level setting. The current setting will start to flash on the display.
Press the SET button a number of times to scroll through the three different settings:
1 Bar
2 Bars
3 Bars
Without having to press any other button to confirm, the display will automatically save the setting and
exit programming mode.
TB 31-41_06-03-2017
ENGLISH
12V 24V
9.6 21.3
10.1 22.3
11.1 24.3
9