Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
B.
When blade is binding, or when
interrupting a cut for any reason,
release the trigger and hold the saw
motionless in the material until the
blade comes to a complete stop.
Never attempt to remove the saw
from the work while the blade is in
motion or KICKBACK may occur.
Investigate and take corrective
actions to eliminate the cause of
blade binding.
C.
When restarting in half-finished cuts,
center the saw blade in the kerf and
check that teeth are not engaged
into the material. If saw blade is
binding, it may walk up or KICKBACK
from the workpiece as the saw is
restarted.
D.
Support large workpieces to minimize
th e risk o f b la d e p in c h i n g a n d
KICKBACK. Large workpieces tend to
sag under their own weight. Supports
must be placed under them on both
sides, near the line of cut and near
the edge of the workpiece.
E.
Do not use dull or damaged blade.
Dull blades produce a narrow kerf
causing excessive friction, blade
binding, and KICKBACK.
F.
The fence lock lever must be tight
and secure before making a cut. If
the adjustment shifts while cutting,
it will cause binding and KICKBACK
o r h i g h s p e e d e j e c t i o n o f t h e
workpiece.
Use only recommended
15.
metal cutting blades, rated at the
machine's maximum rated RPM or
higher with correct arbor hole.
Tighten blade retaining bolt
16.
clamps before operating.
Secure workpiece properly.
17.
should be straight and firmly clamped
t o a v o i d p o s s i b l e m o v e m en t a nd
pinching as the cut nears completion.
ENGLISH
carbide-tipped
and all
Workpiece
9
Allow the blade to come to a complete
18.
s t o p b efore remov i ng or s ecu ri ng
workpiece, or changing workpiece
angle.
Check the inside surfaces
19.
flanges as well as the sides of the blade
for freedom from any foreign matter.
Check the blade
21.
damage before operation. Replace
c r a c k e d o r d a m a g e d b l a d e
immediately.
Never start the tool
21.
against the blade.
Allow the motor to achieve full speed
22.
before cutting.
Do not cut material thicker than the
23.
maximum capacity of the machine.
After turning tool "ON",
24.
tool forward to engage workpiece,
t h e n s l o w l y i n c r e a s e p r e s s u r e a s
required to produce the least amount
of "sparking".
Do not use this tool continuously more
25.
than 31 minutes.
Important: After completing the cut,
26.
raise the motor head, release power
switch, and wait for coasting blade to
stop completely before leaving the
saw.
Never operate
27.
flammable solids, liquids, or gases.
Sparks or hot fragments could cause a
fire or explosion.
This tool is designed for ferrous metals or
28.
aluminum only. Do not attempt to cut
wood, masonry, magnesium, or any
other pyrophoric materials with this tool.
Do not use cutting fluids or lubricants on
29.
the blade.
Some metals have coatings which can
30.
be toxic. Take extra care to prevent
inhal ation a nd skin contact when
working with these materials. Request,
and follow, any safety information
available from your material supplier.
9
of the arbor
for cracks or other
with the workpiece
gently push the
the tool in an area with
Publicidad
Tabla de contenido
