Thrustmaster TX Racing Weel Manual Del Usuario página 11

Attaching the racing wheel's base to a cockpit
1. Place the racing wheel's base on the cockpit shelf.
2. Drive two M6 screws (not included) through the cockpit shelf, then feed them into the two small
threaded holes located beneath the racing wheel.
Important: The length of the M6 screws should not exceed the thickness of the shelf + 12 mm;
longer screws could cause damage to internal components located in the racing wheel's base.
3. If required, tighten the standard attachment system by inserting the fastening screw in the large
threaded hole.
Attaching the pedal set to a cockpit
1. Attach the pedal set using the small threaded holes located beneath it.
2. Drive two M6 screws (not included) through the cockpit shelf, then feed them into the two small
threaded holes located beneath the pedal set.
Important: The length of the M6 screws should not exceed the thickness of the shelf +10 mm;
longer screws could cause damage to internal components located in the pedal set.
MAPPING
At product launch on Xbox One, different action buttons on the wheel will have identical features in the
game.
In the near future, automatically updating your games (automatic updates will be available if your
console is connected to the Internet) and updating your racing wheel's firmware will enable you to
remove these duplicate features and increase the number of individual buttons.
10/16