Safety Instructions - TECshow Dualtec 3-in-1 Manual De Usuario

2. SAFETY INSTRUCTIONS

Keep this equipment away from rain,
moisture and liquids
1. When opening the packing, take all accesso-
ries out, and remove the light to a horizontal
table for good operation. First check whether
the accessories are complete, then check care-
fully whether the whole light has no damage. If
there is any damage, please contact us assoon
as possible.
2. AC Power: Check whether the local power sup-
ply is accordance with the requirements of the
product rated voltage.
3. The product is only suitable for indoor working
environment. The light should keep dry, keep
away from wet, overheat or dusty environ-
ment. Don't come into contact with water and
other liquids to prevent or reduce the risk of
electric shock or fire.
4. Please do not install the light directly on the
surface of the combustible substance.
5. The people who install, operate and maintain
of light professional certificate required.
6. When there are faults of the light, please stop
using the light immediately. Don't try to repair,
please contact the nearest authorized techni-
cal assistance center, if the parts damage,al-
ways use the same type of parts replaced.
7. Don't touch any electrical wiring in the pro-
cess of operation to prevent the risk of electric
shock.
8. To make sure the light working environment
CAUTION!
Take care using this equipment!
High voltage-risk of electric shock!
temperature, the highest do not exceed 40°
the lowest do not exceed -20 °.
9. Under the stable cooling working situation,
the highest temperature of the housing of the
light can reach 80°,please do not touch.
10. The light is design according to the type of
electric shock protection. The light should be
use in good connection grounding power sys-
tem and the ground wire must connect with
the ground wire of the power supply system.
The earth sign port of the light should be con-
nected to the installing fixtures.
11. Do not use the damage of the insulating layer
wire and also do not use the power cord over-
lap on the other wire. When not in use or clean
the light, please disconnect the power, don't
pull the plug in hard or just drag the wires.
12. There are no components inside for mainte-
nance. Before start operation the light, please
check whether all of the shell is installed. In
the case of the shell open used the light ispro-
hibited.
Note: Under any installation, maintenance and
clean the light, please confirm that has cut off the
power cord!
CAUTION!
| Tecshow Dualtec 3 in 1
English version
P. 3