Publicidad
Idiomas disponibles
Idiomas disponibles
HDL 1400
- Connect the gun, the lance and the nozzle as it appears in the instructions.
- open the water
- Before turning on the appliance, press the trigger to release any air remaining in the hose and the pump
- Turn on the switch and pull the trigger. Remember, the motor does not run continuously, only when the trigger is
pulled.
WARNING: RISK OF DAMAGE!
The unit will begin to spray when the trigger is pulled.
When turning off the unit after use, there is still high pressure inside the hose and unit. Point the gun in a safe
direction and release excess pressure. NEVER direct the high pressure water jet towards people or animals.
AUTO ON/OFF
The pressure washer is equipped with an automatic on/off switch. The pressure washer will only operate when the
power switch is in the ON position and the gun trigger is pulled. When you release the trigger to stop spraying water
through the gun, the motor will automatically shut off. Just squeeze the trigger again to continue using the cleaner. To
release the pressure washer, release the trigger and turn the switch to the OFF position. The unit must be completely
OFF when not in use or while unattended.
PURGE THE GUN
It is very important to purge the gun before using the pressure washer. To do this, simply connect the hose to the
pressure washer and squeeze the trigger BEFORE turning on the power. This allows trapped air to be removed from
within the pressure washer and gun prior to using the unit. Continue holding the trigger for about a minute to allow
excess air to escape from the unit. Water will flow through the gun during this procedure.
SAFETY LOCK FOR THE GUN
This pressure washer is equipped with a gun trigger safety lock. When the pressure washer is not in use, use the safety
lock to avoid accidentally activating the high pressure spray.
ADJUSTABLE SPRAY TIP
The adjustable nozzle will allow you to use any variety of spray patterns from a full fan spray (Diagram 1) to a straight
stream spray (Diagram 2). When using the pressure washer to clean wood, decking, siding, vehicles etc., always start
using the fan spray and start spraying from a minimum of 1m away to avoid damaging the surface of the material
being cleaned. Always start by cleaning in a free test area clear of people and objects.
- Warning: High pressure jets can be dangerous if misused. The jet must not be directed at people, live electrical
equipment or the appliance itself.
23
Publicidad
