Sauder Cannery Bridge Serie Instrucciones De Montaje página 12

Step 7
å
Unfold the BACK (F) and lay it over your unit.
å
Fasten the lower edge of the BACK (F) to the BOTTOM
BRACE (J). Use four 1/2" PAN HEAD SCREWS (13).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Finish fastening the BACK (F) to your unit using
the NAILS (6).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the SHELVES (E).
NAIL
(28 used in this step)
2
nd
Page 12
6
These holes must line up
over the SHELVES (E).
F
www.sauder.com/service
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1
st
1/2" PAN HEAD SCREW
(4 used in this step)
J
13
429554