Sauder Hammond Serie Instrucciones De Montaje página 10

Step 5
Step
å
Separate eight EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below.
Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (B and E) and UPRIGHTS (C and D). Use twelve BLACK 5/8" FLAT
HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the ENDS and UPRIGHTS.
Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the release lever up and
pull the SLIDE from the RAIL.
BLACK 5/8" FLAT HEAD SCREW
(12 used in this step)
Closed end
1
Page 10
Open end
Closed end
22
B
C
www.sauder.com
Use these holes.
1
E
1
1
1
1
Closed end
1 hole
st
D
Open end
428247