Sauder Rollingwood Serie Instrucciones De Montaje página 23

Step 17
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other
holes that line up with the holes in the UPRIGHT. Turn a
SCREW into these holes.
å
1 - Fasten one EXTENSION RAIL (1) to the surface with
st
HIDDEN CAMS on the LEFT UPRIGHT (H). Use three 1/2"
PAN HEAD SCREWS (24).
å
2 - Carefully flip the LEFT UPRIGHT (H) over.
nd
å
3 - Fasten one EXTENSION RAIL (1) to the surface
rd
without HIDDEN CAMS on the LEFT UPRIGHT (H). Use
three 1/2" PAN HEAD SCREWS (24).
1/2" PAN HEAD SCREW
(6 used in this step)
431407
24
www.sauder.com/service
1
st
1
H
2
nd
3
rd
1
H
7
Open end
Open end
Page 23