Sauder Rollingwood Serie Instrucciones De Montaje página 8

Step 2
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (1) to the RIGHT END (D). Use three 1/2" PAN HEAD SCREWS (24).
å
NOTE: For the EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
the inner cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the
END. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
1/2" PAN HEAD SCREW
(3 used in this step)
Page 8
24
www.sauder.com/service
Open end
1
D
7
1
431407