Sauder Clifford Place Serie Instrucciones De Montaje página 9

Step 5 Step
å
Separate the EXTENSION SLIDES (R) from the EXTENSION RAILS (Q) as
shown in the enlarged diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (Q) to the ENDS (A and B). Use twelve
BLACK 1/2" PAN HEAD SCREWS (25).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to find the other holes that lines up with the holes in the ENDS.
Turn a SCREW into those holes.
å
NOTE: The EXTENSION SLIDES (R) will be used later for the DRAWERS.
Use these holes.
Open end
421114
Q
Pull down on the black release lever and pull the SLIDE from the RAIL.
Q
Q
Q
B
www.sauder.com/service
R
R
Q
Q
A
BLACK 1/2" PAN HEAD SCREW
(12 used in this step)
7
Open end
25
Page 9