Sauder Clifford Place Serie Instrucciones De Montaje página 20

Step 15
å
Fasten the HINGES (11) to the DOOR (J). Use six SILVER 1/2" FLAT HEAD SCREWS (21).
å
Fasten a PULL (12) to the DOOR (J). Use two SILVER 1/2" FLAT HEAD SCREWS (21).
å
Fasten the HINGES on the DOOR (J) to the HINGE BRACKETS on the RIGHT END (A).
å
Follow the large diagram below to fasten the HINGES to the HINGE BRACKETS keeping the DOOR vertical at all times.
å
Tighten the mounting screws in the HINGE BRACKETS.
SILVER 1/2" FLAT HEAD SCREW
(8 used in this step)
Page 20
21
A
J
www.sauder.com/service
11
Mounting screw
This screw will fit
into this slot. Then
tigthten the screw.
12
J
The screw on the back
side of the HINGE will
fit into this slot.
433364