Publicidad
Idiomas disponibles
Idiomas disponibles
This function is useful to check the correct connection to the control unit and the rotation
direction in case of wind-alarm.
Activate the TEST function, with the sequence B+C, C. The awning opens for 10 seconds
and closes briefly to confirm that the test mode is activated. Move the anemometer
blades by hand, the motor performs short moves in closing direction. If the direction is
not right it's necessary to invert the rotation direction. To quit the test mode press any
button from the remote control. During the wind-alarm the red led inside the control
unit is on.
+
B
C
It is possible to run the motor through a switch connected to the control unit with three
wires (up, down and common).
The switch must be equipped with mechanical or electrical interlock, to prevent
two commands being sent simultaneously. Furthermore, the switch must be an
unstable pushbutton: releasing it, the switch opens.
TEST FOR WIND-SENSOR
(WINDTEC SC)
C
SWITCH
37
Publicidad
