Publicidad
Idiomas disponibles
Idiomas disponibles
product's distributor may cause
personal or material risks or
injuries.
Make sure that the fan is on a
•
stable surface when operating
to prevent overturning.
Do not immerse in water.
•
If the power cord is damaged, it
•
must be replaced by a qualified
person, to avoid risks.
Children should be supervised
•
to make sure they do not play
with the appliance.
This device is not designed to
•
be used by people (including
children)
physical, sensory or mental
abilities or lack of experience
and knowledge, unless they
are supervised by a person
responsible for their safety.
Children should not play with
•
this
device.
maintenance should not be done
by children if they are not under
supervision.
PRODUCT FEATURES:
The contents of the package will contain
the following. See pictures 01 on page 4.
Note: The picture is for reference only. The
content may vary depending on the model.
1. Grill
2. Blades
3. Screw
4. Holder
5. Wheel
You can check the product features in table
01 on page 5.
with
reduced
Cleaning
and
INSTALLATION
Before using this appliance, remove the
packaging and inspect the fan. If the
appliance may be damaged, please contact
the store where you purchased it.
Never operate the fan without its base
and other parts. Operate the fan only in
vertical position; any other position may
be dangerous for the user.
Assemble the base and other parts of the
appliance considering the following notes:
• Place Mounting Bracket on the
underside of the stand halves to left
of the crash roll as shown.
• Install two screws through the
bottom
of
screwdriver
• Slide Axle Rod through Mounting
Bracket
• Install the two wheels onto the Axle
Rod and secure with two Axle Cap
Nuts. Press Axle Cap Nut onto Axle
Rod.
• To assembly the fan body to the
base, place the bracket on the floor
with the left wheel in front of you.
• Holding the main fan body, place on
the base and aligne the holes on the
body and the base. Then fix the body
to the base using the screws.
6. Axle cover
7. Wheel
8. Stick
9. Mounting bracket
10. Screws
11. Wheel
12. Axle cover
13. Holder
14. Grill
15. Holder
See image 02 on page 4.
the
stand
using
EN
a
13
Publicidad
