Dantherm HPP Serie Manual De Instalación página 16

EN
Important.
Unit ON/OFF button
Mode button
Notes:
The adjust buttons
The setting button
Heating mode
Defrosting
Left temperature display
IN 88
°C
Right temperature display
OUT 88
°C
Clock display
Timer 'ON'
ON
Timer 'OFF'
OFF
16
Functions of the buttons on the user interface.
Remember that at startup there is a 3 minute time delay before the HPP heat pump starts
Press this button when the unit is in standby mode. The HPP can be turned 'ON' and run in the setting
mode. When the HPP is in the running mode, temperatures, timer setting and clock times are displayed on
the screen. Press this button again when the HPP is running and the HPP will then be turned 'OFF' .
Press this button to select the running mode at any point. Each time this button is pressed, the mode will
change in the sequence below:
Auto Heating Cooling
1. Parameter 13: Unit mode selection decides the HPP running mode. When set at"0", the HPP is in cooling
mode, and if set at"1", 3 modes are available: Auto, Cooling, Heating. If set at "2", only heating is available.
The HPP supplied is for heating only.
These are the multi-purpose buttons. Combining these with the
used for parameter setting, parameter checking, and timer adjustment.
On main running interface, press
This is a multi-purpose button.
Combining with the
parameter checking, and adjustment of the timer.
Icons on the touchscreen user interface
This icon indicates that the current operation mode is heating.
This icon indicates that the defrosting function is enabled. This is an automatic function where the unit will
enter or exit defrost cycle according to the inner control program. The defrost parameters can be altered.
The unit does not have a manual defrost option.
This display shows the current water inlet temperature.
If you want to check or adjust the parameters, this section will show the relating parameter number. In a
malfunction occurs, this section will show the related error code.
This display shows the ambient temperature.
If you want to check or adjust the parameter, this section will show the related parameter value.
The clock display shows the current time.
When reading or programming the timer settings, the clock display shows the set times.
This icon indicates that the timer 'ON' function is enabled.
This icon indicates that the timer 'OFF' function is enabled.
to adjust the setting temperature.
and and buttons, they are used for parameter setting,
, , and
buttons, they are