Publicidad
Idiomas disponibles
Idiomas disponibles
the
power,
press the steam button (3) to release the residual steam
in the boiler (13
NOTE: Continue to release steam for long time, when pump adds
water into boiler, soleplate will stop to release steam for short time,
almost 10secs.
DRYIRONING
Connec! the appliance to the mains
button(7),
then select the desired temperature by turning the
thermostat knob(4).Wait until the iron heating indicator light (2) goes
off,
indicating that the desired temperature has been reached.
For dry ironing it is not necessary to press the steam button (3).
FILLING THE TANK
Thanks to the self-filling
and wait while the boiler fills up again.
When the water in the boiler is at minimum
automatically activated which fills the boiler once
If you hear the loud feed-water sound when you
there is no water in the water tank (14).Press the switch button (7)
and eut down the
switch button (7) again, go on ironing.
To keep on working, simply restore the water level in the self--refilling
tank as described in the "Preparation for
PUTTNG THE APPLIANCE AWAY
First ensure that the appliance has cooled down completely. Empty
the water tank
lt is not necessary to drain the boiler after ironing.
Steam line (5) and power cord (9) could be receipt into the wire
groove (12) and line box
LOCKING IRON
To Iock the iron it must be set on the rear part of the rest mat (Fig11).
NOTE: make sure to firmly hook the iron to prevent it falling
accidentally.
)
function,
power.
After fill the water tank
( 14)
.
(10).
supply,
there is no longer any need to stop
use"
paragraph.
press the switch
level,
the pump is
again.
ironing,
it means
(14),
then press the
Publicidad
