Member's Mark 730-0830F Instrucciones De Montaje Y Funcionamiento página 11

3. Searing Side Burner Valve Assembly
a) Remove the 2 screws from the searing side
burner. See Fig.3.a1. Remove the searing side
burner. See Fig.3.a2.
b) Loosen but do not remove
pre-attached to the valve. Insert the searing side
burner valve into the searing side burner control
panel and bezel. Align the screws on the valve with
the large side of the holes on the bezel. Slide the
screws down to the smaller holes and tighten the
screws to secure. See Fig.4.a1.
c) Replace the searing side burner, angling it so that
the side burner tube slides over the valve orifice.
See Fig.4.a2.
d) Locked 2 screws removed in step a. See Fig.5.
e) Loosen the screw at the front of the Side Burner
Bowl (C) then align the Side Burner Igniter Wire (L)
to the hole and tighten the screw, See Fig.5.
the 2 screws that are
Assembly Instructions
Fig.3
a1
Fig.4
Fig.5
L
11
a2
a2
a1
C